Whats the best way to strip paint and rust off parts?
#1
PassionFord Post Whore!!
Thread Starter
![Default](https://passionford.com/forum/images/icons/icon1.gif)
As above,
I've stripped the front end of my car down and want to strip all the dirt, paint and rust off the subframe, wishbones, steering rack.....
What the best way to do this?
I bought a spot blaster and although it works, it will take me forever and cost a fortune in media and make an awful mess in my garage.
What else can I do? Other than paint stripper and a wire wheel?
I've stripped the front end of my car down and want to strip all the dirt, paint and rust off the subframe, wishbones, steering rack.....
What the best way to do this?
I bought a spot blaster and although it works, it will take me forever and cost a fortune in media and make an awful mess in my garage.
What else can I do? Other than paint stripper and a wire wheel?
#2
10K+ Poster!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Paint stripper and a wire wheel is a good option, I think all DIY options are fairly time consuming.
#3
I've found that life I needed.. It's HERE!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
find a local vapour blaster, a friend of mine is just about to start up doing it, so i watched a few youtube videos on it, and its amazing and quick
#6
PassionFord Post Whore!!
Thread Starter
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Gunk won't remove paint or rust, only oil and I don't have any of that.
I've tried a normal cup wire wheel on a mini grinder and it takes off the flakey stuff but not really much good at the tough stuff or good paint.
I've ordered some twisted knot wire brushes to see if they're any better.
I've also emailed about 4 different metal finishers about cleaning/priming but I've not had a reply from any yet lol.
I've tried a normal cup wire wheel on a mini grinder and it takes off the flakey stuff but not really much good at the tough stuff or good paint.
I've ordered some twisted knot wire brushes to see if they're any better.
I've also emailed about 4 different metal finishers about cleaning/priming but I've not had a reply from any yet lol.
Thread
Thread Starter
Forum
Replies
Last Post