Clutch options with Tremec gearbox
#1
![Default](https://passionford.com/forum/images/icons/icon1.gif)
This may have been asked before but I have tried the search and not found what im after..
I am after a single plate clutch set-up for the 3dr thats not going to be a nightmare to drive with but will take 450 lb/ft torque as I can no longer stand the twin plate set-up im currently running. In traffic its just horrible and I look rediculus (spelling?) especially when doing hill starts revving the nuts off the car to get it moving without stalling...
So whats my options please?
Also I understand I will need a new flywheel.
Ta
Gav
I am after a single plate clutch set-up for the 3dr thats not going to be a nightmare to drive with but will take 450 lb/ft torque as I can no longer stand the twin plate set-up im currently running. In traffic its just horrible and I look rediculus (spelling?) especially when doing hill starts revving the nuts off the car to get it moving without stalling...
So whats my options please?
Also I understand I will need a new flywheel.
Ta
Gav
![Top](https://passionford.com/forum/images/smilies/smile011.gif)
#2
I've found that life I needed.. It's HERE!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Go ebay USA mate cheap and lots of options for single plates,also normally get the parts within a week,or go on jegs or summit racing website and they have lots very good service,ordered some parts last Thursday night and they arrived yesterday
#3
PassionFord Post Whore!!
iTrader: (11)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Speak to CG Motorsports mate they'll beable to sort you something out even if it's bespoke.
http://www.clutch-specialists.co.uk/
Rich
http://www.clutch-specialists.co.uk/
Rich
#4
![Default](https://passionford.com/forum/images/icons/icon1.gif)
![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
I know its 26 spline but thats it, lol
Speak to CG Motorsports mate they'll beable to sort you something out even if it's bespoke.
http://www.clutch-specialists.co.uk/
Rich
http://www.clutch-specialists.co.uk/
Rich
![Big Grin](https://passionford.com/forum/images/smilies/icon_mrgreen.gif)
#7
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Its on its last legs now and slips at peak torque and bite is at the top of pedal travel, has only covered 2000 miles but assume slipping it so much to pull off has killed it
Whats the correct plate though please? This is what im asking?
Also will I have to change anything with the centre push actuation?
Ta
Gav
![Top](https://passionford.com/forum/images/smilies/smile011.gif)
Trending Topics
#8
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Just find a plate the right diameter and thickness and tell the clutch place to stick a GM 26 spline hub in the middle.
It's 1 1/8" diameter and 26 spline and generic across a lot of US GM cars and Tremec boxes.
It's 1 1/8" diameter and 26 spline and generic across a lot of US GM cars and Tremec boxes.
Thread
Thread Starter
Forum
Replies
Last Post