Where can you get this steering joint bush?
#2
Advanced PassionFord User
iTrader: (2)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
you can get a poly one from burton i think i got mine but a bit fiddly to fit.. their is the excact same rubber on a landrover discovery i got a brand new one last year on ebay for 25 quid.. it looks identical to the original.. i cant see any new ones on their at the mo but im sure that you could find one on the net..
#5
Advanced PassionFord User
iTrader: (2)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
mine has not split but not really had any use out of the car over the last few years... feels much better to drive than the worn out old one that had split.. when the old one went i was on a dual carridgeway and it pulled the car violently to the right.. i should have checked sooner why the steering felt sloppy but i had put heat wrap around the old one years ago so didnt even check it..
Trending Topics
#9
Advanced PassionFord User
iTrader: (2)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
heres how mine ended up when i removed it for a poly one..
![](http://i10.photobucket.com/albums/a147/gibbo4k/diffandcoupling218.jpg)
and this is the same rubber fitted to an 89 - 94 land rover discovery.. just got to remove it from the discovery shaft for when the poly one dies..
![](http://i10.photobucket.com/albums/a147/gibbo4k/diffandcoupling217.jpg)
i got it from island 4x4 in kent if anyone is wanting one..
![](http://i10.photobucket.com/albums/a147/gibbo4k/diffandcoupling218.jpg)
and this is the same rubber fitted to an 89 - 94 land rover discovery.. just got to remove it from the discovery shaft for when the poly one dies..
![](http://i10.photobucket.com/albums/a147/gibbo4k/diffandcoupling217.jpg)
i got it from island 4x4 in kent if anyone is wanting one..
#11
Advanced PassionFord User
iTrader: (2)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
the poly one in mine is holding up ok so far .. i flattened the curved plates as the new bush is totally flat as when i first fitted it with the original brackets you could see the poly flexing where it was not clamped tight all over.. now its all compressed properly it looks to be doing its job with no visible flexing.. just wait for it to melt being next to the screamer pipe....
#12
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Or just a repair section for the rubber ?
Thread
Thread Starter
Forum
Replies
Last Post
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM
DavidK
Ford Sierra/Sapphire/RS500 Cosworth
1
27-09-2015 02:55 PM