My brother has been buiding a s1 cos for the last couple of years and its finally ready for the road.

obviously after pouring somewhere in the region of 10-15 grand into it
he dosnt want to take it to any old bodger to map as it his pride and joy.

can anyone recomend someone near the west sussex area whos good at mapping weber ecu ?

regards john

 

bttt

 

Any pics?

 

I'll take some when I get back home , as I work away alot.

Think about devil developments any one used them/ experiences ?

Regards john

 

Take it to Jano @ okc, He does wonders with cossie management

 

if its running a YB then i would take it to mark shead (MA developments) or up to blackpool to the guys at MSD.

heard nothing but good stories about both, depends who is more local, but for the best service I would travel

 

Do power engineering do it??

Steve Scott at A1 in bedford is a good shout and lovely bloke to boot.

have a squint on the Fast Ford site mate in thier links page, will be loads in there

 

mark shead doesnt map weber stuff anymore though

 

shame mark @ mad dosent map the cossy stuff anymore as i only work 15 mins away

would love to take it and let stu do it but its around 8/9 hour round trip

 

jamsport in northampton

 

lets just say been to jamsport a few times when converting my s2 to efi and didnt find the work to be of a high standard concidering the money i spent

 

plus its a right coont to start from cold

 

grove garage, ahmed bayjoo http://www.grovegarage.com/?page=services

 

i think mark will use msd chips so if the car isnt a strange spec then thats the way forward getting mark to set it up

 

might have to speak to mark and see what he says as the engine is pretty much reguar stuff tbh.

surley if it has the correct chip and all other settings such as timing,co ect is all right surley it should run right?

am i right thinking that live mapping refines the map to suit the engine making the driveability fueling better?

rough spec is as follows

205 block
new forged pistons
forged rods
all new bolts/bearings.
rebuilt head ( new valves, guides , valve seat cut)
std cams
t34
l8 wasted spark

so its not realy groundbreaking stuff lol

 

sounds like that will be fine to just buy the chip from stu ! yeh live map will make it a little better but it wont be far out on a msd chip

 

cheers jay