Sierra Diff pre-load + Backlash
#1
Thread Starter
I'm Finding My Feet Here Now
iTrader: (1)
Joined: May 2004
Posts: 132
Likes: 0
From: Chester
Sierra Diff pre-load + Backlash
Hi all,
The pinion bearings are shot in the diff in my dad's kitcar....
Does anybody know what the pinion bearing preload and CWP backlash should be on a standard sierra 7" open diff ?
Thanks in advance
Pete
The pinion bearings are shot in the diff in my dad's kitcar....
Does anybody know what the pinion bearing preload and CWP backlash should be on a standard sierra 7" open diff ?
Thanks in advance
Pete
#2
Pete,
Although this refers to the scorpio, the procedures are identical...
http://www.fordscorpio.co.uk/transgen.htm
HTH
Ian
Although this refers to the scorpio, the procedures are identical...
http://www.fordscorpio.co.uk/transgen.htm
HTH
Ian
#4
something doest quite add up with that Scorpio spec
it says set the backlash to 0.01mm
then tighten the bearing 4 notches where 4 notches = 0.16mm, in other words remove all the backlash and set it under load
Where am I misinterpreting this, its been a long day at work
it says set the backlash to 0.01mm
then tighten the bearing 4 notches where 4 notches = 0.16mm, in other words remove all the backlash and set it under load
Where am I misinterpreting this, its been a long day at work
Last edited by westysprinter; 27-11-2012 at 07:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
chowfornow
Ford Non RS / XR / ST parts for sale.
14
05-01-2019 09:01 PM
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM