Hello all does any one know what engines sensors i need for efi conversion for my escort rs turbo any infro would be great if some could list them for me

 

what ecu n inlet manifold are you going to use

 

as above depends what system your going to use

 

move this over to tech q and a's

 

Hello mate i be useing the fiesta rs turbo one got complete one of them injectors the lot just need to know what ones i need for the engine will be using ofab loom and ecu got them all connecters and map sensor co2 pot edis 4 etc just need to what engine sensors i need for the loom and engine.

 

if its a escort block you will hav to make up a crank pos sensor cos it dont hav a hole in the block, if you use a fiesta block its got the crank pos sensor hole in it.. The Inlet manifold as water temp, air temp sensors n you need a tps sensor, map sensor, co-pot sensor, o2 sensor, think thats it

 

Ok thanks mate what about the loom it has connecters are there any for the connecters.

 

2 way to do the loom you can use a ofab/ofac loom or a mk4/5 xr3i efi one the escort eri loom is easier to use you hav to change a few wires around on the ecu plug