just a quick question, orded 2 guages 1 oil 1 voltsthese ones does anyone no what size hole and depth is needed to mount them, my dash is out (for another reson) and i want to cut the holes and refit asap so dont want to wait a few days till thay get here, thanks

 

52mm holes for gauges(might have to open them up slightly as the gauges are 52mm) and the gauges front to back are around 3.5-4 inches! well mine are anyway! what car they going in?whereabouts?

 

you will aalso need a adaptor for the sender mate! i ran mine from the oil pressure switch in the block with a t piece that accomodates the sender and the original pressure switch or you can get a sandwhich plate that sits in between the oil filter and block!but never had one of these!

 

thanks mate, there going in a zetec s, not sure were, will see where i can cut