Anybody used AH fabrications coolers?
#1
Anybody used AH fabrications coolers?
What the hell is going on with the pipe that goes into the cooler from the turbo, why does it kink intowards the centre of the engine? It means that the silicone hose from the turbo to the cooler needs cutting to fit aswell as causing an unnecessary bend WTF?!?!? anybody else got one and have a picture to show too?? The outlet pipe seam far too low also as the T/body hose fouls the PAS hoses
Why is this inlet hose below elded onat a kinked angle??
Why is this inlet hose below elded onat a kinked angle??
Last edited by Mr C; 22-08-2009 at 12:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post