dakar

iTrader: (1)

Have just rebuilt the top half of my engine and painted it all up to make it look nice and put the engine back in and have got it all running.Just one problem in that it just cuts out at 3 thousand revs every time.It is ok if you rev it gently as long as you dont exceed 3k.Could it be anything to do with the phase sensor in the dizzy as i took this apart to clean and paint or will the fault be elsewhere.Any help,advice and suggestions gratefully recieved

Cheers

john_p_b

iTrader: (4)

timing?

dakar

iTrader: (1)

Timing is spot on mate

pete mcrash

iTrader: (1)

scrap it.................

Twellsie

iTrader: (1)

mine has exactly the same problem, although it seems to be ok from cold, but as soon as its warmed up it happens

Paul_RS

iTrader: (4)

Fuel pressure reg buggered?

dakar

iTrader: (1)

I think jacko would kill me.... lol

dakar

iTrader: (1)

I may be wrong but i think its electrical as it cuts out bang on 3k every time

cabrio zo

Could be the phase sensor, ours used to 'stutter' and not rev or boost past around 3500rpm (ok if you changed up before then) phase sensor was knackered - wires all broken up - IIRC you need to gap them too (0.2 - 0.2mm) you could've disturbed it?

Z

Dan Higgins

i have a 2004 ford fiesta an just put a new head gasket and oil cooler on it but now the car wont boost atall its slow as piss it wouldent pull you outa bed has any1 any ideas

Billy_RS

iTrader: (5)

Hi jacker! lol