Ok when the car has been disarmed/unlocked for a while, when you want to start it what do you do?
Only way ive found so far is turning the ignition on, then press the button, then turn the ignition back off and on again but surly theres an easier/quicker way?
On my old clifford all i had to do was turn the ignition on all the way, then press the button once and then it would start.

 

All you have to do is turn the ignition to position 2(run) press ARM button and it will reset the immobilser, allowing the igntion lights to come back on and then to start.
If it does not do this I would check where he has taken the power feed(igntion from), on my C5T2, I have to re-arm dis-arm thing but it is on a vauxhall with no accesssory live from the ignition switch.
tabetha

 

what i was doing is turning the ignition to position 3 not 2.

Ill try it later, cheers

 

I just press the disarm button and it works

 

Thats abit vague? at what point do you " press the disarm button"?

When the ignition is in position 2?

 

i just press teh disarm button if im going to the car and its just immobilsed

or if im in teh car igntion on, press the btton and then start the car

 

me too, just press the disarm button again, ign on/off wherever

 

cool cheers guys

 

i also normally just press the disarm/unlock button just before i try n start it, has the same effect as putting it on 2, pressing a button then starting

 

Yep! Thats the way! Always works on mine!