Comp CXN
16-08-2008, 03:12 PM
#41
PassionFord Post Whore!!
iTrader: (9)
Join Date: May 2003
Location: Essex/Middlesex
Posts: 7,836
Likes: 0
Received 0 Likes
on
0 Posts
lol
my kit/arch is still not trimmed yet and thats on 245's. I'll get the hammer and chisel out over the winter and see if i can get some wider rubber on (265's
)
my kit/arch is still not trimmed yet and thats on 245's. I'll get the hammer and chisel out over the winter and see if i can get some wider rubber on (265's
)
16-08-2008, 03:25 PM
#45
PassionFord Post Whore!!
iTrader: (9)
Join Date: May 2003
Location: Essex/Middlesex
Posts: 7,836
Likes: 0
Received 0 Likes
on
0 Posts
put it this way..........i run a 9 inch rear on an ET24 and the kit/arch has not been altered yet!!
i would have had no chance on a 40 profile.
They do catch (only when fully laden) but still not too bad considering the width/offset
i would have had no chance on a 40 profile.
They do catch (only when fully laden) but still not too bad considering the width/offset
16-08-2008, 04:58 PM
#47
Mulechild
iTrader: (3)
Join Date: Feb 2006
Location: North Wales
Posts: 1,667
Likes: 0
Received 0 Likes
on
0 Posts
i've got 245-35 on my 8x17 et15 rears and it does catch but only when laden or when booting it and the shocks are set soft..
Last edited by philram; 16-08-2008 at 04:59 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Focosmitch
Ford Focus RS Parts for Sale.
5
09-03-2016 01:03 PM
