Davey8oy

heres a bit more info on it try page 12

http://www.zf.com/amt/content/media/...2005/25787.pdf

dunketh

I feel they missed an opportunity here, they could have gone full 'double-wishbone' had they relocated the strut and not used it as a cheap way to locate the hub.

dojj

iTrader: (3)

so all they've done is basicly made the hub sit taller by offsetting the location of the strut further inboard?

i'm sure it's more complicated than that but that's al i see, plus a lot more to go wrong althgouh the additional ball jint at the top should stop this from being a problem

cjwood555

Double wishbone setup would have very short wishbones due to packaging restrictions which would result in undesireable dynamic geometry....