Setting Throttle postion sensor?
06-08-2008, 07:39 AM
#2
MAD Carbon Cossie
iTrader: (1)
Join Date: May 2004
Location: South London
Posts: 2,899
Likes: 0
Received 0 Likes
on
0 Posts
I was always told, disconnect the throttle cable from the linkage, undo the the 2 philips screws a few turns, pull the TPS off a few mil & then tighten.
Not 100% accurate, but will just about do !!
Hope this helps
jb
Not 100% accurate, but will just about do !!
Hope this helps
jb
06-08-2008, 12:20 PM
#3
PassionFord Post Whore!!
Join Date: Sep 2003
Location: Macclesfield - you'll never leave....!
Posts: 4,519
Likes: 0
Received 1 Like
on
1 Post
hmmm. there is a correct method for the PF09 (4x4) type, and im sure there is one for PF01 (2wd) but i dont know what it is, as they work in opposite ways to each other....
Thread
Thread Starter
Forum
Replies
Last Post