Zvh block and pistons
#1
I've found that life I needed.. It's HERE!!
Thread Starter
Join Date: Dec 2006
Location: oxford
Posts: 1,374
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Would the pistons and rods from "smitsturbo" st170 biuld fit and work in a pre 98 mondeo block its 2ltr???
#3
Borg Warner EFR Equipped!
Join Date: Apr 2005
Location: In the unit, building a 450bhp Time Attack Focus!
Posts: 5,810
Likes: 0
Received 2 Likes
on
2 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Yup,
As Si said - straight in - just remember that the STs ran a higher compression ratio partly down to the head - 8cc smaller chamber in the head but some on the pistons as well i believe.
As Si said - straight in - just remember that the STs ran a higher compression ratio partly down to the head - 8cc smaller chamber in the head but some on the pistons as well i believe.
#5
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by m4dyeti
Is he selling up then
i believe he got them through Ian Howell so best to contact him to advise on cr ratio of the pistons then a quick deck of the block, bore and you got a bottom end suitable for around 450 bhp![Top](https://passionford.com/forum/images/smilies/smile011.gif)
![Surprised](https://passionford.com/forum/images/smilies/shocked.gif)
i believe he got them through Ian Howell so best to contact him to advise on cr ratio of the pistons then a quick deck of the block, bore and you got a bottom end suitable for around 450 bhp
![Top](https://passionford.com/forum/images/smilies/smile011.gif)
S.
#6
Lukesville
iTrader: (2)
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by sas
Originally Posted by m4dyeti
Is he selling up then
i believe he got them through Ian Howell so best to contact him to advise on cr ratio of the pistons then a quick deck of the block, bore and you got a bottom end suitable for around 450 bhp![Top](https://passionford.com/forum/images/smilies/smile011.gif)
![Surprised](https://passionford.com/forum/images/smilies/shocked.gif)
i believe he got them through Ian Howell so best to contact him to advise on cr ratio of the pistons then a quick deck of the block, bore and you got a bottom end suitable for around 450 bhp
![Top](https://passionford.com/forum/images/smilies/smile011.gif)
S.
![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
in that cast ignore what i just mumbled
![Surprised](https://passionford.com/forum/images/smilies/bigcry.gif)
![Surprised](https://passionford.com/forum/images/smilies/bigcry.gif)
![Surprised](https://passionford.com/forum/images/smilies/bigcry.gif)
Cheers Si
![Wink](https://passionford.com/forum/images/smilies/icon_wink.gif)
![Big Grin](https://passionford.com/forum/images/smilies/icon_mrgreen.gif)
Thread
Thread Starter
Forum
Replies
Last Post
deathrider666
Technical help Q & A
3
28-09-2015 06:12 PM