clifford alarm help!
#1
Regular Contributor
Thread Starter
Join Date: Dec 2006
Location: Darlington
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
clifford alarm help!
hi,
Ive just finished my engine conversion, but when ignition is on there is no lights on the dash, and i think this is down to my immobiliser(clifford concept 600) because it is not flashing like it normally does and i believe a wire that i have not plugged in is related to that...
so does anyone know where this wire goes? circled red
I know before i took it out it went through the strut brace and into the dizzy area, i pulled it out by mistake and ive completely forgot where it goes but i think this is the cause of the problem.
Car is a honda civic fitted with an integra type r engine.
Thanks
Dave
Ive just finished my engine conversion, but when ignition is on there is no lights on the dash, and i think this is down to my immobiliser(clifford concept 600) because it is not flashing like it normally does and i believe a wire that i have not plugged in is related to that...
so does anyone know where this wire goes? circled red
I know before i took it out it went through the strut brace and into the dizzy area, i pulled it out by mistake and ive completely forgot where it goes but i think this is the cause of the problem.
Car is a honda civic fitted with an integra type r engine.
Thanks
Dave
Thread
Thread Starter
Forum
Replies
Last Post