Right here goes.

I bought an ALPINE CDE-9828RB stereo Headunit off of ebay, got it and the cables had all been cut and bullet connected as they were obv too cheap to buy a propper ISO connector. The positive and negative for the 2 rear speakers were just cut, no bullet connectors at all. So they could have never even worked in the previous car.

So I go to halfords at 7.30 last night, got some bullet connectors and repaired the wiring, and it all works spot on!

Now though, the front left speaker has a dodgy connection, so where can I get a whole new fitting kit for this stereo????? I.e the part that comes out the back of the headunit into the ISO connector block

If I can't get one, I'm just gonna have to cut all the bullets off and solder it all I guess, but they're alerady short enough as it is

Many thanks

 

Alpine themselves m8, check there website.
Just tell them you need a new wiring harness for your model and they will send ya one.

I recently got one delivered for one I had.

 

ALPINE do them mate i got one from them about a year ago for the same unit about £30

 

Excellent

Do you still know their official website Benn?

 

support@alpine-electronics.co.uk

 

£30

 

I got mine off ebay too was ment to be brand new but when i got it it did'nt have the power loom with it but i got the guy i bought it from to pay for the new loom
Here's the web site for alpine if you still want it
http://www.alpine-europe.com

 

the rear speakers were probably just soldered and he cut em off.

i solder mine all the time fuck buying a new ISO everytime i swap cars they are £10 a time and i swap cars monthly

 

Not if you get 'em off ebay they're not!!

I soldered them all on now, and its fine again