Kill/Master Switch
#1
PassionFord Post Troll
Thread Starter
Join Date: May 2003
Location: Leeds
Posts: 2,892
Likes: 0
Received 0 Likes
on
0 Posts
Kill/Master Switch
I've relocated my battery to the boot and I want to use a master/kill switch to connect the two positive cables up and allow me to switch the battery feed of quickly and easily in the future.
One like this fitted under the bonnet...the question is how are they mounted? I can't make out any way of mounting them from the pictures?
Also whats the difference between the standard switch and the FIA spec switch which is twice as expensive?
One like this fitted under the bonnet...the question is how are they mounted? I can't make out any way of mounting them from the pictures?
Also whats the difference between the standard switch and the FIA spec switch which is twice as expensive?
#2
Advanced PassionFord User
the neck of the switch is back entry through the panel, so you remove the rubber cover push it through the panel cut-out then retain with 2 M4 bolts IIRC....
#4
PassionFord Post Troll
Thread Starter
Join Date: May 2003
Location: Leeds
Posts: 2,892
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys....I don't want it through the scuttle so I'll use a bracket like Tony says.
I don't plan to 'Kill' then engine either just use it as a switch so I'll go for the non-FIA
I don't plan to 'Kill' then engine either just use it as a switch so I'll go for the non-FIA
Thread
Thread Starter
Forum
Replies
Last Post
rsguy
General Car Related Discussion.
44
29-09-2015 03:29 PM