Piston and bore clearance
#1
I've found that life I needed.. It's HERE!!
Thread Starter
Piston and bore clearance
I am rebuilding a spare 205 block that I have with some 4x4 Mahle pistons.
The spec I am going for is roughly 350 BHP with a t34 and greens, the Pistons have a few hundred miles on them but measure 91.26mm, so what is a good bore size to head for? I understand that the tolerance should allow for more Clearnace that standard due to heat of extra power, but is it massively different for my spec?
The spec I am going for is roughly 350 BHP with a t34 and greens, the Pistons have a few hundred miles on them but measure 91.26mm, so what is a good bore size to head for? I understand that the tolerance should allow for more Clearnace that standard due to heat of extra power, but is it massively different for my spec?
Last edited by KW-rscos; 20-06-2015 at 07:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post
deathrider666
Technical help Q & A
3
28-09-2015 06:12 PM
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM