Collins engine monitor
08-02-2014, 08:46 PM
#1
Collins engine monitor
As above brand new only trial fitted brought from mike £250 Ono plus postage
The monitor is available as a standard version and also as a professional version (the standard version is priced above). The monitor displays real-time engine management parameters, these include: Engine RPM (rpm), Coolant Temperature (ºC), Charge Air Temperature (ºC), Boost Pressure (absolute) (bar), Battery Voltage (V), Throttle Position (º), Ignition Timing (º BTDC), Fuel Injector Opening Time (mS), Sensor Fault Detection, 4 channels of analogue data (optional), Current Ignition Map Address (Professional Version only), Current Fuel Map Address (Professional Version only), Blanket Fuel Adjustment (Professional Version only), Blanket Ignition Adjustment (Professional Version only), The monitor works with ‘Ford Cosworths' that run the Magneti Marelli L6, L8 or P8 ECU if the correct Powerchip / Pectel chip is also fitted. So this includes all ECUs running Pectel / Collins boards (the comms support may need enabling, which we can do for a small charge on L8s, but some P8s may need a £50 mod to the board). Having spoken to MSD, I am lead to believe that some of their software also supports this, but you would have to confirm with them to be sure before ordering, as many do not, as they obviously favour their own IAD monitoring software. Easy to install - plugs into ECU diagnostic connector. PLEASE NOTE IF YOUR ECU IS NOT LISTED ABOVE IT WILL NOT WORK, NOR WILL IT BE PRODUCED AT A LATER DATE. Delivery is extra
The monitor is available as a standard version and also as a professional version (the standard version is priced above). The monitor displays real-time engine management parameters, these include: Engine RPM (rpm), Coolant Temperature (ºC), Charge Air Temperature (ºC), Boost Pressure (absolute) (bar), Battery Voltage (V), Throttle Position (º), Ignition Timing (º BTDC), Fuel Injector Opening Time (mS), Sensor Fault Detection, 4 channels of analogue data (optional), Current Ignition Map Address (Professional Version only), Current Fuel Map Address (Professional Version only), Blanket Fuel Adjustment (Professional Version only), Blanket Ignition Adjustment (Professional Version only), The monitor works with ‘Ford Cosworths' that run the Magneti Marelli L6, L8 or P8 ECU if the correct Powerchip / Pectel chip is also fitted. So this includes all ECUs running Pectel / Collins boards (the comms support may need enabling, which we can do for a small charge on L8s, but some P8s may need a £50 mod to the board). Having spoken to MSD, I am lead to believe that some of their software also supports this, but you would have to confirm with them to be sure before ordering, as many do not, as they obviously favour their own IAD monitoring software. Easy to install - plugs into ECU diagnostic connector. PLEASE NOTE IF YOUR ECU IS NOT LISTED ABOVE IT WILL NOT WORK, NOR WILL IT BE PRODUCED AT A LATER DATE. Delivery is extra
Thread
Thread Starter
Forum
Replies
Last Post
Sierrasideways
Ford Sierra/Sapphire/RS500 Cosworth
15
31-08-2015 10:10 AM
JoeyBoyden
General Car Related Discussion.
0
18-08-2015 10:52 PM