Sold
09-12-2012, 11:51 AM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
09-12-2012, 12:24 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Gearbox now sold
Thanks
Last edited by mbfordnut; 18-01-2013 at 08:23 PM .
09-12-2012, 12:29 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
mbfordnut
4x4 7" Quaife ATB diff with alloy mount (£130) and drive shafts.
3000miles. 900 on this car and just over 2000 on my last sapphire. Nice condition
£650
Diff mount sold so just shafts and diff itself
£625
09-12-2012, 12:49 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
4 x 60lb Siemens sold
Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min
Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms
Turn off time: 0.85ms @ 600KPa
Connector: Bosch EV1
Series: DEKA 4 ( DEKA IV )
Orifice Type: Multi-orifice
Spray Pattern: 30 Degree Spray Cone
Factory fitted with Viton upper and lower o-rings
Last edited by mbfordnut; 17-12-2012 at 08:00 PM .
09-12-2012, 12:50 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
4 x 55lb Siemens low impedence injectors
As new only trial fitted
Sold
Last edited by mbfordnut; 10-12-2012 at 07:07 PM .
09-12-2012, 03:52 PM
PassionFord Regular
Join Date: Jun 2003
Location: Belgium
Posts: 427
How much for the hart inlet?
09-12-2012, 04:14 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
Bart
How much for the hart inlet?
£500 with t25 70mm throttle, cable bracket, vac take offs and sensors on throttle
Sold
Last edited by mbfordnut; 14-01-2013 at 11:23 AM .
09-12-2012, 05:56 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Gearbox - sold
Siemese inlet and fuel rail - sold
Oil cooler and diff hanger - sold
Front diff - sold
Nitrous - sold
09-12-2012, 06:33 PM
PassionFord Regular
Join Date: Jun 2003
Location: Belgium
Posts: 427
Quote:
Originally Posted by
mbfordnut
£500 with t25 70mm throttle, cable bracket, vac take offs and sensors on throttle
I only need the bare inlet. Would you sell like this?
09-12-2012, 06:50 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
Bart
I only need the bare inlet. Would you sell like this?
Would be about £450
09-12-2012, 06:51 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Rear diff provisionally sold
Brakes provisionally sold
10-12-2012, 03:35 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Fuel pump and filter sold
-8 lines, fittings, swirl tanks and regulator still avaliable. Message for details
10-12-2012, 03:48 PM
cossie fan (unluckerly)
Join Date: Nov 2009
Location: hampshire
Posts: 9,791
I was thinking when I pick that intercooler up I may as well take the cooler to throttle body hose as well as I'm on a st one also if your sell it
10-12-2012, 03:59 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
ajamesc
I was thinking when I pick that intercooler up I may as well take the cooler to throttle body hose as well as I'm on a st one also if your sell it
Ill go 1 better you can have it..
10-12-2012, 09:52 PM
Too many posts.. I need a life!!
Join Date: Jul 2009
Location: Bracknell
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
cant be fairer than that....
11-12-2012, 10:10 AM
TT T38 Power
Join Date: Apr 2005
Location: Somerset
Posts: 22,368
I wish i had seen the 55lb injectors
Very good prices mate
Steve
11-12-2012, 12:10 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Stack st200 0-8000 rpm tachometer.
Brand new in box only opened to photo and check contents.
Complete with manuals and cable.
I paid £240 inc postage
Both demon tweeks and JJC £240 with postage
Sold
Last edited by mbfordnut; 19-12-2012 at 06:02 PM .
11-12-2012, 12:19 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Stack fuel pressure guage and mounting pod with braided loom and pressure sensor for regulator.
Non original stack sensor, custom braided loom with heat shrink. Gauge in good working order. Dash mount pod.
0-7 bar.
£148 + p&p from tweeks
Now sold
Last edited by mbfordnut; 17-12-2012 at 05:53 PM .
12-12-2012, 07:29 AM
10K+ Poster!!
Join Date: Feb 2008
Location: god knows
Posts: 12,876
pm sent
12-12-2012, 07:51 AM
10K+ Poster!!
Join Date: Feb 2008
Location: god knows
Posts: 12,876
martin ,could i have your paypal address please
12-12-2012, 08:10 AM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
james kiely
martin ,could i have your paypal address please
Hart plenhum and T25 throttle with sensors now sold to james Kiely.
Thanks again for the deposit
12-12-2012, 09:59 AM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Breather tank, seperator, header, bailey pas tank and swirl pot now sold.
Thanks
Last edited by mbfordnut; 12-12-2012 at 10:28 AM .
14-12-2012, 01:33 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
14-12-2012, 01:37 PM
PassionFord Post Whore!!
Join Date: May 2004
Posts: 5,618
Likes: 0
Received 0 Likes
on
0 Posts
Hi mate.
The rear anti roll bar links arms. Are they for sale? If so how much?
Thanks
14-12-2012, 02:15 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
RONNIE AMIS
Hi mate.
The rear anti roll bar links arms. Are they for sale? If so how much?
Thanks
The white line (gold) on the rear?
Was going to sell as a part of the wishbone and anti roll bar setup but I would split.
£50 on their own
£90 with Cosworth roll bar modded and powerflex mounts
Price inc postage
14-12-2012, 02:29 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
mbfordnut
The white line (gold) on the rear?
Was going to sell as a part of the wishbone and anti roll bar setup but I would split.
£50 on their own
£90 with Cosworth roll bar modded and powerflex mounts
Price inc postage
Would be more with the wishbones, rear axle ect.
But that would need collection
Thanks
14-12-2012, 03:14 PM
PassionFord Post Whore!!
Join Date: May 2004
Posts: 5,618
Likes: 0
Received 0 Likes
on
0 Posts
Just on there own. Ok it's a deal. Is PayPal ok?
14-12-2012, 03:33 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
RONNIE AMIS
Just on there own. Ok it's a deal. Is PayPal ok?
No problem a pm is sent.
Will remove and send monday
15-12-2012, 05:30 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Air filter sold
Clutch setup. Prov sold
Driveshafts sold
16-12-2012, 01:00 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Spec r cooler package sold
16-12-2012, 06:23 PM
Too many posts.. I need a life!!
Join Date: Aug 2004
Posts: 873
Received 0 Likes
on
0 Posts
16-12-2012, 06:29 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Yes APs now sold
And rear diff sold too
16-12-2012, 06:39 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Rear brackets to run 330mm x 28mm AP rotors and 4 pot calipers. Comes with machined caliper carriers and recon handbrake calipers and machined down greenstuff pads. kit for both sides with virtually new cable as I had to change it 300miles ago.
Sold
Last edited by mbfordnut; 17-12-2012 at 05:46 PM .
17-12-2012, 07:36 PM
Glennvestite
Join Date: Jul 2006
Location: Darlington county durham
Posts: 62,761
Gutted the diff mount has sold.
18-12-2012, 08:53 PM
Too many posts.. I need a life!!
Join Date: Jul 2007
Location: Munich/GER
Posts: 662
Any pics of the head and it's height? Of course price also!
Last edited by DaveCrack; 18-12-2012 at 08:59 PM .
19-12-2012, 06:01 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by
DaveCrack
Any pics of the head and it's height? Of course price also!
Will be removing head soon
20-12-2012, 02:09 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
I have 2 sets of front drive shafts.
Stripped cleaned painted and new boots.
These are not re-manufactured but do have good joints and bearings.
Cv boots and ties were £35 alone.
Both sets are standard 4x4 length.
Breakers always asking for £100+ for a set of manky old 1s straight off car.
£95 a set posted UK only.
1 set sold so 1 left!!!!
Last edited by mbfordnut; 06-01-2013 at 10:24 PM .
22-12-2012, 04:48 PM
Advanced PassionFord User
Join Date: Apr 2004
Location: gatwick
Posts: 1,923
What's price on turbo with manifold , screamer and bits Please ?
22-12-2012, 04:52 PM
Regular Contributor
Thread Starter
Join Date: Jan 2006
Location: camberley
Posts: 301
Received 0 Likes
on
0 Posts
Hi mate £1250 for everything including manifold, external gate, oil lines and water feeds. Even included bailey damper
24-12-2012, 01:36 PM
Too many posts.. I need a life!!
Join Date: Oct 2010
Location: south
Posts: 516
What clutch was it running and is it for sale