Im doing a wheel stud conversion and need to know how i get the hab part that the wheel bolts screw into? Mite aswell fit a new wheel bearing while im at it so how do i remove bearing and centre part of hub?

Cheers

 

remove brake caliper and carrier, disconnect track rod end, bottom ball joint, driveshaft nut, slide cv joint out of hub. undo shocker to hub bolt and knock the bearing housing off the shocker, you can then seperate the hub and bearings etc

 

The hub is already off, just need to know how i get off the part of the hub that the wheel/disk bolts to as it dosnt seem to want to come out. Dont know if it needs to be pressed out etc?

 

yes mate will have to be pressed out