How to get Inlet manifold looking like new ??
#1
Too many posts.. I need a life!!
Thread Starter
Join Date: Sep 2004
Location: Aberdeen
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
How to get Inlet manifold looking like new ??
Been thinking about how best to clean up the inlet manifold etc on my Series 1 while the engine is out.....but not sure.
Has anyone done this before ?
I had considered sand blasting the outside of it, but dont know if there are any good / bad points about doing this ?
Also if i wire wheel it....it will come up different to how it left the factory...
Powder coating it is an option, but that will take away some of the casting marks ?
Any suggestions / tried and tested methods welcome folks !
Thanks
Michael
Has anyone done this before ?
I had considered sand blasting the outside of it, but dont know if there are any good / bad points about doing this ?
Also if i wire wheel it....it will come up different to how it left the factory...
Powder coating it is an option, but that will take away some of the casting marks ?
Any suggestions / tried and tested methods welcome folks !
Thanks
Michael
Thread
Thread Starter
Forum
Replies
Last Post
nicodinho
Ford Non RS / XR / ST parts for sale.
6
07-10-2015 12:56 PM
Johnny Knoxville
General Car Related Discussion.
4
30-09-2015 07:21 AM
caprixpack
General Car Related Discussion.
0
25-09-2015 07:53 PM