I have a 200 block with standard YB knock sensor being managed by Motec M800 ecu.
Can you advise the frequency the ecu should be configured for to detect knock condition.

I tried this in the Sierra group, but no response, maybe too many 2WD blocks without standard knock sensors


Thanks
Gavan

 

Depends on youre bore. It is around 6,3khz for a cossie but you will have to check this.

 

Thanks Bart, thats a great start, I have a 200 block with 1st oversize bore, is that what you are asking for ?

 

I don't think that would make any difference.

Martin

 

I will go with 6.3KHz and see how it turns out, thanks