Would anyone be interested in a fully cast and machined inlet, similar to those seen on all the top engines in rallycross, i think you know the one

it would be Made from LM25 Aluminium, and the finish can either be bare, or coated or annodised

cost would be about around £1000 per inlet, including rails, and machined for a desired TB or left as a blank face.

This would be a limited run of 20 inlets.

 

Ryan,
The MIS manifolds are high flow at the expense of response, UNLESS you do what Martin did to his....

 

i think doing that would push costs way beyond what people would pay?

unless its not that much different in price to do 4 jenvey TB's