2.0 Zetec bottom end steel rods, forged pistons etc
Thread Starter
10K+ Poster!!
iTrader: (3)
Joined: May 2003
Posts: 12,493
Likes: 12
From: Stevenage, Herts
Bought this last Saturday from Fudgey from his old 3rd that got rear ended.....
2.0 silver top bottom end
Skimmed block face
7.8:1 compression ratio
Carillo steel rods
Forged Wossner pistons with ceramic coated skirts
New crank on standard grind
Heavy duty bearings
New oil pump
New water pump
Alloy bottom pulley
Engine covered 157 miles before the car was rear ended....
I was planning on using this in my Focus RS but being a silvertop its not compatible so I'm aboning the project and going back to rebuilding my engine....
Now I only want what I paid....(minus the fuel I used for the 220 mile trip to collect)...
£1000 no offers...!!!!
2.0 silver top bottom end
Skimmed block face
7.8:1 compression ratio
Carillo steel rods
Forged Wossner pistons with ceramic coated skirts
New crank on standard grind
Heavy duty bearings
New oil pump
New water pump
Alloy bottom pulley
Engine covered 157 miles before the car was rear ended....
I was planning on using this in my Focus RS but being a silvertop its not compatible so I'm aboning the project and going back to rebuilding my engine....
Now I only want what I paid....(minus the fuel I used for the 220 mile trip to collect)...
£1000 no offers...!!!!
Last edited by SteveB; May 17, 2011 at 07:35 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post











