Where can i get some stainless tubing made up the same as the pic's below?????




and a below engine pic



Basically just 2 pipes, i could provide pretty accurate measurements so i dont think who every makes them will actually need the car. Can anybody on here knock me sumin up????

 

Fookin Hell how big are those pic's.

Lee @Fusion is your man though.

 

Try Lee @ Fusion Fabircations mate

 

LOL, he seems to be the person to ask then.

anybody got a email or do u reckon he'll see this thread???

 

Put a FAO Lee@Fusion mate mate or PM him.

 

Any steel stock holder look in the yellow pages i used ASD.

I made my own exhaust out of 3". It was Ł85 for 6mtrs and the sweeping bends are Ł10 each.

 

www.fusionfabrication.com

and 0787 964 8628

 

and ive edited your foookin huuuuuuuuge pic

 

try http://www.ecosse-peugeot.co.uk/ thats a hdi engine from a pug or try cituning

 

No shit sherlock, how DID you work that one out

 

Ecosse charge WELL over the top for all the work they do, plus not good at keeping to deadlines etc etc

Also there about 600miles from me

and yeah i knew it was a hdi engine LOL

 

is it me or do the pipes stick down a long way under the car

 

They do hang down quite low, But in that pic there is no front bumper on the car, when the bumper is on the pipework is about leval with the bottem of the bumper.

Unfortunatly there is no other way of routing the pipework from the turbo behind the engine to a front mount intercooler.

The 206 engine bay is stupidy small the the hdi engine stupidly large