I'm looking to put a RST engine from my mk3 fiesta into a mk1 fiesta van. Can anyone tell me if I need to cut the bulk head and or any mods to the inner arches? cheers.

 

You will need a conversion plate to fit the cvh engine mount, you can get these from the fiesta centre

 

if you plan on putting the 5 speed box in you will also need to cut and modify the n/s chassis leg, but again there is a kit available to buy for this

 

cheers guys

 

Zetec turbo its the way forward get it done dude

 

zetec turbo boo! go zvh

 

as siad inner arch on pass side and engine moutn plate, just cut the inner wing the put some box section in where u cut out to put strenth there, no need for tie bar mod or nowt, my mk1 fiesta van ran standed xr2 tie bars all i did was cut inner wing and put some box section round where i cut out and my mate done the same