My new Saff !!!
Took a few snaps today after giving the old girl a wash down. I managed to do a few jobs too; replaced the standard three spoke jobbie with my trusty old RS four spoke, removed a few grease marks from the trim with a dab of petrol, scraped off the 'Power by Cosworth' sticker that was stuck on the rear window and removed the alarm company stickers from the front windows and removed the 'cut to fit' mats that were in it and put my genuine Ford OE supplied rubber mats.




Next job is to remove the silver stipes down the side as they're not really to my liking and give it a bloody good T-Cut/claying session and polish it too. I've got some Tar Ox 40 groove discs and pads to go on too as well as some Koni adjustables. I just need to get some springs.




Next job is to remove the silver stipes down the side as they're not really to my liking and give it a bloody good T-Cut/claying session and polish it too. I've got some Tar Ox 40 groove discs and pads to go on too as well as some Koni adjustables. I just need to get some springs.
Trending Topics
Joined: Jul 2003
Posts: 1,455
Likes: 0
From: Milton Keynes
Very nice mate. As said above loads of potential. If you,re going to put konis on try and get some Ahmed springs. Not the cheapest but I,ve just put a set on my Saph with Konis and I'm very impressed with them. Not too low and very comfortable.
Thread
Thread Starter
Forum
Replies
Last Post
cossie330
Ford Sierra/Sapphire/RS500 Cosworth
6
Oct 7, 2015 08:22 PM
mrmann
Restorations, Rebuilds & Projects.
1
Aug 20, 2015 11:24 PM




