as above. took rear beam and trailing arms to the powder coaters. they said i needed bushes out. to make life easier i have a second pair of trailing arms that i have given them but my mate cant get my beam bushes out

help! tips please!

need them out asap to get car back together asap!

 

Knock or pull out, some cossie have bearings instead of bushes in there so might need a bit of a whack.
tabetha

 

I left my trailing arm bushes in and they came out of powder coating fine being spherical joints and not rubber bushes...dunno if saffys just have run of the mill stuff being the lower class breed The beam its self ive found the easiest way being to just cut them out.

 

when i done mine i burnt them out

 

take the beam back to mine and I will take them out chop

 

looks like i'll have to do that Phil, what a pain tho

if you havent seen my thread in general discussion you might not know i cant get standard trailing arm bushes! not sure what to do! might have to rescue my old ones. at least get them out and see what like they are

 

They will most likely need heat to get them out we can see what happins, just fitted new clutch to car so good for go on sunday at knockhill

 

you going to KH with philbert Chop?

 

i've threatened to the last couple of times but have been busy. i doubt i can go this weekend either as we're getting a new puppy and i have fri, sat, sun to assist with house training

i'll be down soon for sure