copy of post on cossy area - rs500 tuned up motor set up
Hi all - hope someone can start to point me in the right direction. Have just installed a low comp (7.1) tuned up motor with BD 14 cams etc. Got it ticking over on what I believe to be a standard chip and a set of yellows - but wouldn't rev... perhaps not suprising so far? Way too lean I believe? Crypton tune said so too.
Put my greys on it and vroom - what a difference... until the plugs sooted up.
New plugs and vroom again for about 2 miles - then pop, splutter, and backfires galore (scared the hell out of the girls in the car behind us). Cleaned the plugs with a brush but no difference.
I need to get it to a rolling road so now a trailer job looks likely, unless someone thinks of a potential obvious oversight, I'm just putting it down to the engine's highly tuned state and lack of chip to support it?
Any thoughts appreciated folks
Put my greys on it and vroom - what a difference... until the plugs sooted up.
New plugs and vroom again for about 2 miles - then pop, splutter, and backfires galore (scared the hell out of the girls in the car behind us). Cleaned the plugs with a brush but no difference.
I need to get it to a rolling road so now a trailer job looks likely, unless someone thinks of a potential obvious oversight, I'm just putting it down to the engine's highly tuned state and lack of chip to support it?
Any thoughts appreciated folks
Thread
Thread Starter
Forum
Replies
Last Post



