Last year I also bought a set of solid beam mounts, not from MSD but someone else. This weekend I was planning on fitting them. But after looking at them closely they seem to have the same problem as those from the OP.


The total height seems too low. On the picture you can see the solid beam mount versus a standard bush and versus the tube from a Powerflex bush. The solid beam mount is about 2 cm lower than the two others.


When you fit a beam bush the tube is clamped between the hole in het chassis rail and the guide plate. But on the solid mount this is much shorter, so the guide plate would go too far up IMO. Are these mounts machined incorrectly, or am I missing something?