Originally Posted by
haz87
As above, were they definitley located in the injector groove. Did you fit new sleeves over them as these usually crack/are beyond their best.
And presume you clamped them all down properly too?
They're usually not 'that' difficult to refit with new seals so does seem odd you had troubles
Yeah I would say they are correct they are from Burton power.
http://www.burtonpower.com/fuel-injector-seal-ford-cvh-mfi-cv725.html
I pushed the seal up and into the groove on the injector and pushed it into the white plastic tube on the San which plate (would you call these the sleeve?) But they were extremely hard to get in there even with a little oil to lubricate. Eventually I did it but I think I have pinched them as said above or broken one!
What am I doing wrong? Haynes manual does not help!