Originally Posted by
bassboy
Passenger side footwell is the best place to drill, high up, drill hole, clean it up, protect it, grommit in, cable through, tidy up
Just make sure there are no cables running anywhere on the opposite side of you drilling lol
i've got to swap the entire dash over at some point so i'll probably do it when i strip the whole thing out for the facelift version
Originally Posted by
RichieST
What I've done is made a hole with a pen knife in the outer bit of the main loom grommet, pushed the wire through there then a bit of sealant around it to make sure it seals well.
did that when i ran the amp power cable and, to be honest, there's not THAT much space left afterwards, and theres not that much space left to begin with so even though i knew what i had to do, actually doing that same thing was impossible due to the lack of space
on the hunt for actual grommets now that aren't just your normal grommet, but have that extra bit to cover some of the cable as well to make it properly water and engine smog tight