Okay, so I have a mk1 focus with 2.0 litre zetec turbo and have put some st170 dials in to allow for higher revometer and Speedo. However it does not light up properly. I have seen a bit of information about it needing the oil temp/pressure gauges to work. I have these and ideally would like them to work also but from what I read this is not possible as the info comes from the st170 ecu. So basically, how do I. A. Get the dials to light up and B. Get the oil gauges to work? If I can't get the oil gauges to work at all then I will either ditch them behind the dash unless I can get the dials to light up without them at all? Any help would be much appreciated. Thanks, Ali.