just a small update:
i was given some heat proof matting from saphcosmike(cheers mate)wich was left over from his car.mines no where near ready for this but thought id get it ready for when it is.
firstly made a template:


which resulted in this:



i know it needs some fibres trimmed around the edges but this will done before its glued to the car.
i re-fitted the abs block and brake master cylinder to check to make sure the brake lines are going to clear the clutch master cylinder,which they did after bending slightly.brake lines now ready for powdercoat.






also picked up some pwdercoated parts on friday.