Originally Posted by
stevealien
Hi peeps
Quick question.
I have a s2 rst I've just fitted omex too.
The cps runs off a toothed trigger wheel on the fan belt pulley.
It's running ok ish , would the distance between the trigger wheel and the sensor affect running ?
Or would it simply run or not run ?
Cheers guys
Originally Posted by
stevealien
I don't have any instructions or anything.
The only prob I seem to be having is car won't start when hot and idle is fluctuating alot.
Seems to drive ok but when Ron drops to tick over I have to blip the pedal to keep it going cos if I let the Rpm drop to tickOver by itself it will stall
So you've fitted the ecu yourself with no instructions at all ? Dont you even see a problem there yourself ?
So is this a new install that has never ran, or one that previously did run, you've done something and now it wont run ?
I'm assuming you have no means of communicating with the ecu either ? and it would seem obvious from your posts, that the base setup has never been carried out, and then mapped for your engine ?