Originally Posted by
stevealien
Thanks Steve
I have no idea about diagnostics.
When I removed it from a friends rst I think it was almost touching the trigger wheel. I put a small washer between the sensor and bracket to bring it out a tiny bit more cos it looked too close.
Is there a general setting for the gap here ? Should it be set with a feeler gauge ?
Every ecu is different as Ive said. No idea what Omex is like
Too close and the gaps may not be seen....and too far away and again nothing will be seen
Aim for around 0.5-1mm, although that also depends on the diameter of the wheel and tooth spacing. On a small wheel 1mm might be too much.