Right ive come to the point where i need to open up the ports one my zetec head, its a silvertop 2ltr with ST170 inlet and tb's, cams etc.

Problem is the ST170 inlet is approx 5mm wider all around the zetec inlet port, thus interfering with the injector spary pattern and air flow.

Has any one self ported the inlet side of the head to the max and found how thick the inlet walls are, particually around the inlet face?.

I need to know if i can do say a 45 deg chamfer (sp) 5mm around the face and abviously 5mm into the inlet port without going into a water jacket etc

Also is it worth removing the valve guide where it protrudes into the inlet trackt, if so whats the best way to do this?

CheeRS

Bri.