Originally Posted by
Bailes1992
I won't lie, pig of a job! Easy, but an absolute pig without removing the inlet.
Part number from ford is FMU 1337254 and I paid £12.15 for it.
The hope just pulls off, I removed the idle speed control valve (and if you have it) the wiring going to the MAP sensor.
A little bit of oil on each end of the hose to push it on and some patients. Will go on eventually.
This is a picture I took showing everything I removed
Think I've named it all.
Have fun
That's a breather pipe, and you removed ALL THAT to replace it? I've done that in about 30seconds on the same engine in a smaller engine bay without removing a thing!
To dan, as it's only a breather pipe, any correct diameter pipe should do the job! Tbh, gaffa tape would be fine.