Originally Posted by
COCHYN
Ideally, but it wasn't necessary
You best stick the beam on first and then the diff, if it all lines up then you're good to go. I'm assuming this was once road worthy right? If it doesn't fit, ask the original owner some questions about the original setup.
it came with a beam on it to make it roll for collection so the beam deffo fits, im assuming that i need to split the hanger from the diff and sandwich that piece hanging down on either side of the diff and the hanger with the two bolts that bolt the diff and hanger together, if i then drill the four holes up through the floor and hang properly with metal above and below for strength and then make a bracket to hold the roll bar???????
last owner had a group a beam on it, are these mounting points for the normal beam the same??????