Hello guys,

I'm working on my project EFI engine running megasquirt. I have a original MFI loom in the car. I was thinking about cutting all the crap that i don't use.

What did you guys do?

I was thinking about only leaving the lights and the watertemp sensor that controls the fan. Which of the watertemp sensors controls the fan? There are lots of temp sensors On the right of the head; After the thermostat and i believe there are also sensors on the rear of the block.

Does anybody have an electronic schematic of the ECU? I think i have some in my haynes manual, but probably not the ECU controls.

Can you remove the old ECU? Or is fan control is in the original ECU?

Cheers! I hope for some nice reactions. I'm going to start with it on friday