Hi Chaps ,

well the 2.1 is in and running as you all know ,

But she is way way way overfueling , black smoke commin out of the zorst and is gassin me out the workshop .

Basicly i have used a Xr3i full car loom ( efi) and converted it to FRST spec usin rag tops conversion notes . http://bbs.rsownersclub.co.uk/showth...threadid=37369

These are

ECU pin changes Pin 27 ( brown) move to pin 8 , for the c/o signal wire ?
Pin 45 (brown/yellow) move to, 27 for the MAP sensor ?

Remove pin 2 ( blue/yellow) in the EDIS module ??

For those in the know are these correct ??

as i said the car runs , a bit rough but think this is due to fueling


Timin has been quadrouple checked , tried a new ECU , c/o adjuster
map sensor and various other sensors just incase these are at fault .

The c/o doesnt seem to be adjustable at all so this leads me to think its a wiring fault .

Fuel pressure has been se and i have a permenent gusge so id know if anything was wrong ,

have lowered the pressure ( naughty i know ) and it makes the engine run a lot smoother

When u open the throttle it just dies , cuts out , again it leads to over fueling .

Any ideas ???????????????????????????/

Short of taking it to have all the wiring checked out .

Does any one have a ESCORT EFI wiring diagram as the haynes only shows one for the fiestas and not the escorts ?????

Thanks in advnce .