Originally Posted by
boy-racer-1
have you got a pik of the pipe ends which originally conected to the tap? as the ends might already have a valve on, as far as i can tell the pipes heading up in the top of the pik would be what the tap was connected to?, so you need to cut them not too short and fit an isolation valve then the flexi's to the isolation valves as boothy said
Just above the top of the picture the pipes go straight into the tap, there are no extra valves. I presume I'd need to fit a pair around here, as the flexis are quite long.
Originally Posted by
S3an
why have you got two washing machine pipes going to the same pipe?
Because that's the way I roll!
Originally Posted by
3drstretch
And yeh dont forget turn both hot and cold water off and drain pipes off using washing maching valves
Will do, although I'll also cover everything in towels. DIY plumbing wouldn't be DIY pluming without a bit of main's pressure water squirting in your face!!