Megasquirt upgrade to MS-II and 3-bar Map HELP
Hi all,
I've just started building my engine and figured i should look ahead to megasquirt fitting etc.
I want to upgrade my current MS1 to MS2, is this as simple as buying an MS2 daughter board and plugging it in? And where is the best place to get the MS2 board?
Secondly, im pretty sure my current ecu has the 2-bar or at best 2.5 bar map sensor from digi-key, what 3bar map sensor can i use? can i use a cosworth 3bar sensor?
Thirdly, my ecu was originally from M-tech automotive, it has the coil pack drivers etcetc, but i read the megasquirt ecus from M-tech were not legit? is this likely to cause me issues when loading new code etc....
Any advice would be great.
Thanks very much!
Rob,