Well its time for a catch up
things have been a bit slow lately due to loosing my enthusiam
but starting to get it back again
after selling quite alot of parts recently to get my funds level back up
mainly things that are no good to me which my change of plans
as basically this car wont look the same as before,
more factory looking with subtle touches
firstly my new black samco hoses for the mk3 fiesta with zetec engine
(the kits only been released a few months ago after all these years)
spark lead clip, new washer jets, clips to hold the wiring in the boot, and tailgate grommet
brand new hubs to go with the knuckles i have'nt picked up from the powder coaters yet
new rear license plate lamp on the left, compared to the old yellow on the right
the metal shim that goes between the block and gearbox, no longer available new
so straightened mine up, sanded back to bare metal as it was a little scabby
etch primer and few coats of satin black, JOB DONE
also the panel gap below the rear light i've had lead filled, so basically its slightly flexable and wont crack
heres how the shell is looking
basically seam sealer is being put on only where its needed and nowhere near as thick as it comes from factory
recently while in the london area, i went to see chris todd @ torque of the devil
about mapping, wiring and management
very happy to leave the car with them in the near future
