PassionFord - Ford Focus, Escort & RS Forum Discussion - View Single Post - My 3dr Cosworth project updated (16.01.12)*

Apr 9, 2010 | 05:25 PM

#869

Gav Diamond

PassionFord Post Whore!!

iTrader: (6)

Joined: May 2003

Posts: 4,382

Likes: 9

From: West Midlands

Quote:

Originally Posted by COLEYST200

bit of hard work never hert any one look at it this way 3 more to go

It hurts when you put your hand in the way of the wire wheel

lol

Quote:

Originally Posted by GAZBEAMCOZ

and the floor !!!!!!!!!

Is that an offer to help Gaz?? lol

Quote:

Originally Posted by mercury grey minter

I took mine down to bare metal then etch primed it.As iv,e said before,it,s a f*cking terrible job but you are only going to do it once and the results are unbelievable.
Good luck.

Thanks mate, im just going to the original primer as i see no reason to go beyond this but will be etch priming on the erea's where i went through, thank you for the advice

Quote:

Originally Posted by Twins

Looking good Gav ,ready for central day then ?

Erm.....can't see it going this year, lol. Don't think my little caster wheels will servive the 80mile journey there

Quote:

Originally Posted by tommytxr

looks soooooo good m8 i run out of steam with my sierra then i read things like this n i start all over

Nice to hear it is giving someone else motivation

I don't mind doing the work as long as i can see some progress, nothing worse than spending a day on it to look at it and think nothing has really been done.

Reply

0