Originally Posted by Rob_DOHC

can any one tell me what trim the standard t3 for an rs turbo would be?

Currently my exhaust housing says .36 I think this is a 2wd cosworth turbo....?

and karlos, did your electronic boost controller control boost drop off a bit better?

The car currently peaks at 17.5 and falls very quickly to i think 14/15 psi this is with a new -31 actuator.... are there any ways to make the car hold boost better?

And i am about to start sourcing bits... what brand/model of bearing to people suggest? i don't think i will change the small ends as i have heard this is difficult to do and has often lead to them prematurely wearing. These will not be bought until my engine is stripped as i want to insect the crank etc first...

Rob,