Originally Posted by
Dark-Horse
Did you offered the shells into the cap's/block dry?
Anyhow .. If it's spinning free then "Bingo"
no mate they have all been oiled
Originally Posted by
Will @ M Developments
I see you're on ARP Main studs mate...
1) Did you use the moly lube as i can't see any on there and it's critical to get the correct stretch in relation to the listed torque figures.
2) Have you tried the intermediate section of the sump on there yet as i had to die grind clearance channels out of mine to clear the stud!
yes mate used the lube you can see it all over the nutts on the second pic
no mate not tryed the sump on yet but i will have the same problem you did