Afternoon all,

Who runs Dreamscience either forced induction or not? And in particular who has had it custom tuned to their engine? I am looking at sodding off my Bluefin for my focus 1.8 zetec that's just had Stage 2 Cams in and getting Dreamscience in the near future. The power my car now makes is pretty good, I'm really happy with it (145.2 HP and rises all the way to the redline) but the torque is slightly down. Makes 127ft.lbs from 5000rpm flat to the redline but I'm convinced I can get more out of it in terms of torque. It was producing 140ft.lbs before on a different set of rollers however. Even if you ignore the figures, the torque drop is definitely very noticeable but the relentless pull till 7000rpm is very much more appreciated instead of it dying off before. In fact, enough dribble from me, here is the graph:



Like I said, I'm convinced that the torque curve could be improved with some decent mapping on management like Dreamscience that will allow a lot more control over parameters rather than the Bluefin even though this has been altered by Superchips. People have even got better results running no sort of flash map at all just on the standard ECU. Dreamscience is looking the most likely candidate (DSF2000 or DSF3000). Also considering but not as much a Dastek Unichip or one of the MSD Evolution Chips as they can be mapped apparently but yet to find anyone that can do that in my area (North London). Would want to go back to TOTD too ideally to have the mapping done as they did the work on the car and RR'd it and have been pleased with their service.

So what are your thoughts guys? Cheers!