Originally Posted by
SteveH
Thats awesome!!
Sort of thing I want to get MS doing.
Do you just tell it to keep between x and y AFR, x and y degrees advance/retard etc, or does it literally do the entire thing from scratch?
how good is the map when its done? do you think intelligent input from a good mapper could get it any better?
i think afr side no i dont think a mapper willl do any better manual as its quicker
the bloke who put this ecu on cossie bassie cossie from the netherlands hadd a good afr up to 1.5 bar on a dirty 3o from nothing but a simple base to start map 2o mins later it was safe and drivable ! the ecu the when held on a particular site will also add or subtract to the sites front and back up and down around the site it is also adjusting. BUT its only as good as its initail setup to parameters ect
ingintion is really what chip says BUT would realisticly spend a hour on the rollers with det cans also using the rollers to find peak power/torque